This version of the Martin Baker MB.3 was built and did fly as a prototype. Initially it did not have the guns fitted at a latter stage the proposed guns were fitted, the options are included in the kit. Further  options are included in the kit treaded tyres and a 'hooked' rudder for WHAT-IF carrier use. 

The kit comprises of sixty-five resin parts, forty-five parts will be used to complete the model.

The kit comprises the following sets of parts

• Thirty-eight 3D printed parts, six of which are alternate parts
• Twelve small 3D printed parts in a protective cage, two of which are for other versions, and 5 spares of the useable small parts for loss or breakage (printed in with more flexibility)
• Three 3D printed undercarriage struts (printed with more rigidity)
• Four 3D printed clear parts for wing tips and gunsight, an extra gunsight included
• Four clear cast resin canopy parts allowing for open or closed canopy
• Set of canopy masks
• Decals, this is a sheet that covers this version and others
• Stunning A4 poster
• Instructions

The kit is supplied with a set of laser printed decals. The decal are thin, work easily and have good opacity, and they DO NOT look all digitized or pixelated when applied.

Note the decals supplied are a generic sheet for all three of the MB fighters in my range.

The kit will need preparation by the modeler and the supports that are generated will require removing. This is easily done and as long as care is taken then they have been designed to be easily removed. The model will require either a super glue or an epoxy glue for assembly, however, I find PVA can also be suitable in certain areas and for trialing the fit and assembly before committing to the permanent glues. 

Note this kit is also available in 1/72 scale

PLEASE ALLOW 3-4 WEEKS MANUFACTURING TIME